Need more information?

• Central GSMSAR
• Software configuration GSMSAR
• Antenna
• Connectors GSMSAR
• 5 magnetic detectors
• 15 meters of cable 4 wires.
• 0.5 meters of termoretractil

By GSMSAR of Teknosolar can receive an alert on his mobile phone when incidence occurs in photovoltaic.

The GSMSAR of Teknosolar device is a transmitter / receiver GSM SMS messages that have inputs and outputs for monitoring and activating devices remotely.

The system is designed for the protection of photovoltaic installations by sensors installed in the panels. It also allows access to detect the location of the batteries, inverter and controller. Likewise we can monitor the temperature in the room with a probe batteries optional.

The mounting system is extremely simple, in short, we must install a SIM card from any operator without PIN configured, configure the device according to our needs with simple software including wire sensors in the panels and making connections in GSMSAR.
Once it detects any change in the condition of the sensors, is configured GSMSAR act as sending an SMS to cellphone, telling the reason of the occurrence.
GSMSAR can change the relay outputs to launch devices based on the state of the sensors or commands sent from our mobile phone.

• Power: 12V DC or 220VAC/50Hz
• Modem TC65 (v3.0) Siemens MOBILE DATA SOLUTIONS GSM850/900/1800/1900 with quad-processing capacity built and run by a Java processor and ARM7 ™
• Consumption at rest: <1 W
• Max:> 4W (relay activated in the process of sending SMS)
• Dimensions (mm): 140x110x35
• Operating Temperature: -10 º C to +65 º C
• 4 digital inputs
  To four relay outputs: Outputs 1 and 2, maximum 10A 220VAC, common and normally open contacts on each. Outputs 3 and 4 maximum 5A 220VAC, common contacts, normally open and normally closed on each.
• USB 1.1/2.0 interface for PC connection
• 1 input for temperature sensor (optional) through an RJ45 connector

REQUIREMENTS

• GSM Coverage
• SIM card of any operator
• PC Windows XP or higher